NO. You would also have to change the transmission and install a 2-wheel drive transmission. The center shaft in the 4-wheel drive transmissions are longer so the transfer case will work.
Yes - make sure the transmission and transfer case are in neutral. Take it easy & you'll be fine. Yes - make sure the transmission and transfer case are in neutral. Take it easy & you'll be fine.
3
Motorcraft MERCON automatic transmission fluid is used in the transfer case
Take the bottom pain off
700r4 if its an automatic
The one with the 4hi, 4lo, 2hi and auto 4wd buttons takes GM auto-trak II transfer case fluid.
5 min
22
I belive the transmission will take sincromesh fluid found and any gm dealer and your transfer case will take dexatron III fluid.
Heat transfer is in three modes. Conduction, convection and radiation. In case of conduction, the speed of transfer depends on the conduction property of the material. In case of convection, the speed of transfer depends on the density of the liquid. In case of radiation, the speed of transfer of heat is at the speed of light in air medium and a little bit less in other denser medium.
you have to take all the bell housing bolts out.then make sure all shaft are lose as well, losen the support bracket under the transfer case and make sure the engine is supported along with the transmission and slowly work it down. then unmount the transfer case to the tranny and it should all fall into place by then
look at the transfer case,theres a fill hole and a drain hole both with bolts to take out. You can also search on youtube to see a vid.