0
What is the relation betweenfty allowable stress and factor of safety?
Wiki User
∙ 11y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the relation between yield stress and allowable stress?
A factor of safety against yield is applied to design stress Yield Stress/ Design Stress = Factor of safety The factor of safety varies for different industries; 1.5 is used in structural steel design for buildings; 1.25 or even 1.1 for aircraft/space systems
What is the difference between a safety factor and a factor of safety?
Both are meaning the same definition. simply you put factor beyond the safety.
Is factor of safety of brittle material half of ductile material?
is factor of safety of brittle material half of ductile material
What is difference between partial factor of safety and factor of safety?
A safety factor is an aspect of design that increases strength or protection beyond that suggested as needed by calculation or other basic assessment. For example, engineering calculations might suggest a bridge needs a certain amount of strength in a support beam. That number would be increased by, perhaps, 20% as a "safety factor" in case it were to be stressed beyond its design or in case some basis for the calculation was in error.A partial safety factor is one of several safety factors applied to the same instance.
What is the safety factor used for civil engineering?
2
What is the relation between ultimate and allowable stress?
ultimate stress=Factor of safety*Allowable stress
What is the relation between yield stress and allowable stress?
A factor of safety against yield is applied to design stress Yield Stress/ Design Stress = Factor of safety The factor of safety varies for different industries; 1.5 is used in structural steel design for buildings; 1.25 or even 1.1 for aircraft/space systems
What is allowable stresses?
The maximum allowable stress is that value beyond which, after applying an appropriate factor of safety its particular strength criterion is exceeded and failure occurs. For example, if aluminum strength in yield is 35,000 psi, and factor of safety is 1.25, its maximum allowable stress against yield is 35,000/1.25 = 28,000 psi
What is the difference between factor of safety and safety factor?
There is no difference between "factor of safety" and "safety factor." They are two ways of saying the same thing.
What do you mean by partial safety factor?
The factor of safety for loads is known as partial safety factor. Partial safety factor=Design load/Characteristicload
What is Mac in safety and health?
In health and safety, MAC stands for Maximum Allowable Concentration. This is the name of an exposure standard used in Germany.
What is the difference between a safety factor and a factor of safety?
Both are meaning the same definition. simply you put factor beyond the safety.
What is the difference between a safety factor and a safety precaution?
A safety factor is a number designers use when designing structures. a Higher safety factor is used if the structure undergoes frequent loading. A safety precaution is an act implemented by a human that does not jeoperdize his or her safety
What is the factory of safety?
Did you mean what is the factor of safety
What is the minimum allowable side distance from 480 volt electrical panel and emergency safety shower?
30 inches
How factor of safety is determined in the design?
factor of safety are usually determined from the past statistics of the working element.
What is the normal allowable source voltage deviation from the motors nameplate voltage rating?
It can be 10% min and 5% max.AnswerA nameplate voltage is a 'nominal voltage', and manufacturers normally design their products for the allowable variation in nominal voltage of the country in which they are to be marketed. So, for those products intended for, say, the British market, manufacturers would take into account the British allowable variation, which is 230 V (+10%/-6%). And, no doubt, most manufacturers would widen this variation to allow a 'factor of safety' for their products.
