Top Answer
User Avatar
Wiki User
Answered 2006-11-09 04:49:22

Inside the distributor on my 94 B250 is a plastic piece that covers the bottom of the distributor. Ihas a wire coming out of it. On it, it has a mark and says number one cylinder, or something like that. But it is there.


Your Answer

Related Questions

It was available with a four, six, or eight cylinder engine.

There are several oil return holes in the cylinder heads.

inside the distributor along with the crankshaft position and cylinder position sensors

I'm not a mechanic / technician but as far as I know ( YES ) I checked the Gates website and it shows that the 2.2 liter 4 cylinder in a 1994 Dodge Shadow is NOT an interference engine

If you are talking about installing or removing the ignition lock cylinder I believe the key has to be in the run position.

No, just the pick up plate in the distributor.

It is a non-interference design if you have a 4 cylinder version

Back side of the engine, under the manifolds.

1994 Honda accord ex remove rear rotor

Passenger side of the block. Near the trans bell housing.

Its located on the firewall... it is just sticking out, it has a 3 wire connection to it as well as a vaccum line coming from it.

There was no 1994 Neon.There was no 1994 Neon.

No signal from crank position sensor during engine cranking.

For a 1994 Ford E-250 , 4.9L / 300 cubic inch inline 6 cylinder engine : The firing order is ( 1 - 5 - 3 - 6 - 2 - 4 ) The distributor rotor turns CLOCKWISE ( looking from the top ) The marked # 1 position on the distributor cap faces AWAY from the engine The engine cylinders are 1 through 6 , from front to rear

You will need to remove the cylinder head from your 1994 Chevy. Remove the head gasket and clean the surface. Put the new head gasket on and put the cylinder head back to its original position.

no1 on the distributor always points towards the no one cylinder

In 1994, Dodge used Emerald Green Pearl Metallic.

1 - 5 - 3 - 6 - 2 - 4 ( for the 4.9 liter / 300 cubic inch straight six cylinder ) The distributor rotor turns CLOCKWISE The marked # 1 position on the distributor cap faces AWAY from the engine

If a Dodge Ram 1994-1997 If a Dodge Caravan 1992-1995

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.