answersLogoWhite

0

What is the set of a pipe run?

User Avatar

Anonymous

13y ago
Updated: 4/8/2023

The set is called a Jordan M. set

User Avatar

Arianna Blick

Lvl 10
2y ago

What else can I help you with?

Related Questions

What is the set of a pipe-run?

The set is called a Jordan M. set


What does B.O.P. stand for in piping?

For horizontal run pipe it is Bottom of Pipe For vertical run Pipe it is back of pipe


How much is a half pipe?

A 4ft Half pipe will run about 1500 at the cheapest.


How do you test a perforated pipe?

Not with air! Run water in pipe at highest elevation of pipe and see that water drains at end of pipe system.


What the difference between weldolet and thredolet?

A weldolet is a fitting you weld on a (run) pipe, and then butt weld a branch pipe to it. A tredolet is a fitting you weld on a (run) pipe, and then screw a threaded branch pipe to it. Some people call this a threadolet A sockolet is a fitting you weld on a (run) pipe, and then socket weld a branch pipe to it. A nipolet is the same as a weldolet or thredolet but has an elongated branch connection. You have to specify if it's a welded or threaded nipolet.


Can you fix a sprinkler pipe with duct tape?

Yes, temporarily. In the long run it's more efficient to get the pipe glue relevant to that pipe,


Why does water run out of overflow pipe in homes?

because whatever is on the other end of that overflow pipe is overflowing


Callculating rise and run when laying pipe?

!/8 in of rise to 1 foot of run.


How do you maintain exhaust pipe in DG set?

the romans


When installing a closet flange to a drain pipe in a concrete floor is there any problem with filling gap around pipe with cement and bolting brass flange to cement rather than attaching to drain pipe?

The bolts that come from the drain and run to to toilet help to alaign proper drainage and seal the toilet. You do not want to do the bolts set in cement idea...


What set of tongs are used to break the drill pipe?

the breakout set or dummy roughneck side


How do you cut a 42 inch pipe?

to cut 42 " pipe place the pipe on a set of bearingspower driven .place a torch on a stand so it is steady .have the pipe roll about 10 inches per minute.thatis what we do.