0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the maximum size of an IP packet carrying an ICMP packet?
The maximum for any IP packet via ethernet is limited to a maximum of 1508 characters. ICMP packets are typically small but can be configured to use any amount of characters up to the maximum size of a packet.
What sets ATM apart from Ethernet is the size of its what?
Its fixed packet size.
What information is not included in a Ethernet frame?
Frame Size
What is the size of an RARP packet when the protocol is IP and the hardware is Ethernet?
28 byte
When creating a packet how does the network layer determine the size of the packet?
The Network layer (Layer 3, typically IP) will receive a segment from the Transport layer (Layer 4, typically TCP or UDP), and will add its own header to it to create a packet. The size of the packet will thus always be the size of the segment plus the Network layer header, the same as when the next layer down (the Data Link layer, layer 2, typically Ethernet) encapsulates the packet into a frame for transmission.
What is the minimum and maximum size of an Ethernet frame?
The minimum size of an Ethernet frame is 64 bytes. Even if the VLAN tag is 4 bytes, the Ethernet frame with VLAN tagging remains 64 bytes.
What is added when extra filler data is needed in a packet?
In Computer networking, you have data that is transmitted through packets. In which is what we call an Ethernet frame. That Ethernet frame broken up into several pieces. They are:The PreambleRecipient's MACSender MACTypeData (Your information)Pad (FILLER)FCSThe reason why we have the "Pad" is because your standard minimum for an Ethernet frame size is 64 bytes. However, it doesn't all have to be your actual data. For example, if you were to send data that was not 64 bytes. Your NIC (Network Interface Card) will automatically add extra data which is what we can the "Pad" portion. This adds data so that we are back up to the minimum value of 64 bytes within an Ethernet frame.
What is the maximum number of bytes that is allowed in a standard IEEE 802.3 Ethernet frame?
Totally depends on the hardware and software and their MTU (Maximum Transmission Unit). Usually MTU is set to 1500 bytes.
Why a packet has limit of 63 characters?
A packet does not have a limit of 63 characters - depending on the protocol it may have a total size of 1508 and beyond; the actual data is somewhat smaller but not limited to 63 characters. For Ethernet frames, 64 characters is closer to the minimum size for data.
What is a packet?
In most, but not all networks, rather than transmitting data in small pieces such a single character at a time, data will be sent in a larger piece referred to as a packet. The size of the packet is a tradeoff between network sharing, speed and error detection and recovery. Standard Ethernet uses a packet size of about 1500 bytes, while Wi-Fi defaults to a bit more than 2300 bytes.
What are the differences between segment packet and frame?
Theoretically Data Link Layer puts packet into frame by adding header and tail to the packet but how is it possible when you take into consideration CCSDS packet definition:"A packet is a block of data with length that can vary between successive packets, ranging from 7 to 65,542 bytes, including the packet header.Packetized data are transmitted via frames, which are fixed-length data blocks. The size of a frame, including frame header and control information, can range up to 2048 bytes."According to this, frame is smaller than packet, so how can you put packet into frame??
How many MB equals 1 packet?
A packet can vary a lot in size, but can be 1.000 bytes or 1,500 bytes in size. So a packet is like a set of information or files that each packet can vary in size. Typically it is not a small size at times, but can be.
