10mm or 12mm metric 10mm or 12mm metric
The bolts on a 94 Dodge Intrepid valve cover need to be very tight. You should tighten to 12 N*m or 105 inch pounds.
There are valve cover bolts around the perimeter of the valve cover. You want these tight but not as tight as you can get them.
Begin by removing the valve cover from your 1995 Dodge. Remove the valve cover gasket and clean the surface. Put the new gasket on and return the valve cover to its original position.
remove the valve cover pull off the valve cover gasket and put new one up making sure you dont over tighten the valve cover bolts make sure you have correct torque replace all the o rings inside valve cover while changing main gasket for best results
First you loosen 11 Bolts with a 10mm socket,after you take out the sparkplug boots,Gently pry up cover with a flat head screwdriver,your done!
they are dropped down inside the valve cover. pull the plug wires and use a plug socket and extension to reach them.
Your head bolts are located under your valve cover. Take your valve cover off and you will see them. Hope this info. helped.
4x4
Top of the valve cover.Top of the valve cover.
There are 4 bolts going through the center of the valve cover.
If you are asking because of your valve cover leaking oil, there was a recall on that year valve cover gasket.
The valve cover on a 1996 Cadillac is held on by several bolts around the edge. After removing any hoses, fuel rail, or anything else in the way, remove the bolts to pull the valve cover off.