0
What is the size pipe in front of the muffler o a 92 Saturn sl2 1.9?
Wiki User
∙ 12y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the stock exhaust pipe size on a 1998 silverado?
its about 2.5" but that is from the headers to the muffler and the tail pipe is 3"
What is the diameter of an exhaust system for a SUNFIRE 2000 2.2 going into the muffler and exiting the muffler also the clamp size?
put your mouth to the tail pipe!
What is the inlet and outlet size of a stock 1994 Saturn SC2 Muffler?
I'm thinking it was 1 1/2" when I did mine.
1987 Toyota Celica GTS Muffler pipe diameter size?
We have a 1988 Celica GTS and we just replaced our pipes...they were 2"....should be the same....
What is the stock exhaust pipe size on 1998 silverado?
depending on the size of engine 5.7 lt (350) is duels into the muffler of 3in pipe and single 3in out to the rear of truck 5lt (305) 2in y pipe to cat and duel 2 inch tail pipes (454) 3in same as 5.7lt
What size speakers does a 94 Saturn sl1 have?
6.5" round speakers in the front and back.
How to change a muffler on Chevy S-10?
First off, crawl under the truck and see if your present muffler is welded on or clamped on. If it's welded on you will need to get an exhaust cutting tool from like Autozone and cut the old muffler off BUT before you do, get your new muffler and measure how far the inlet neck is and outlet neck is on the new muffler and this will tell you how far to cut. You could hold the new muffler up to the exhasut and mark how far from the muffler you need to cut. This is assumign you are replacing the bad muffler with a new one of the same size. Now there is an inlet pipe and and out let pipe on the muffler. You will also need to have the right size clamps. Pu tone clamp on the exhaust pipe going to the engine, then push the exhaust pipe into the inlet end of the muffler and slide the clamp down and snug it up but do not tighten it. Put the other clamp on the exhaust pipe towrd the rear of the truck, push the exhasut ipe into the outlet end of the muffler and then slide the clamp down onto the joint and snug up. if everythign aligns right, then tighten the clamps. Sometimes if you overtighten the clamps you will have exhaust leaks. If you cannot get the joints to seal, you may need to get your system welded. If you exhaust is leak free then you are done. After a few hot and cold cycles you may just want to crawl back under and check the bolts on the clamps just in case they came loose from the heat and cold cycles.
What size front and rear speakers come standard on a 1995 Saturn SL?
i have the same question?
Where is the horn located on a 2002 Saturn L200?
On the LW200 it is in front of then right front tire, just behind the bumper. It is small, about the size of your hand.
What is the size of the factory speakers on a 1995 Saturn SC1?
6 1/2 inches in the front and rear.
What is th size of Saturn?
the size of saturn is as big as my pinky
What size is the Diameter of the exhaust pipe between the muffler and the resonator I want to repair a crack without replacing both for an estimated 700?
By the way this is a 2001 infinity QX4 By the way this is a 2001 infinity QX4
