what size thread is the oil switch sensor in a range rover 1994 4.2
v8
Let me guess it's a range rover 2.5 1994-2002 so it's a diesel sport edition
Jaguar
According to www . motorcraft . com ( no spaces ) the IAT sensor is a thread in type for the engines in a 1994 Ford Ranger - so threaded into the upper area of the intake manifold somewhere
When standing in front and over the engine it is 'beside' the distributer.
have a 1994 land rover discovery & dont have owners manual. where i can i get one?
left hand thread
184366572
It is threaded so (I am guessing you have a new one already) hopefully you know where the sensor is located. Just disconnect the old sensor, being careful not to break the retaining clip on plug, and thread the old one out with the proper size wrench, if the new sensor does not have thread sealant on it already you will need to apply a small amount to the threads, and install the new sensor. Be very careful not to over-tighten new sensor so you do not break it!!! It just needs to be tight enough not to leak, plug in the wires again and you should be done.
Beethoven - 1994 A Cat Named Rover The Dog Must Diet 1-8 was released on: USA: 29 October 1994
A MAF sensor was not used in 1994. It don't have one.
The 1994 S10 uses a MAP sensor, not a MAF sensor. We need to know size engine you have in that S10.
The 1994 Dodge Intrepid O2 sensor is located on the outside of the air cleaner housing. The sensor is on the back side of the housing.