Sounds like something somebody added on.
It should be a toggle switch right above the radio
Toggle = back and forth, or on and off. A toggle switch toggles (turns) a light or other device on or off. Good example is a light switch (the wall kind)-- a toggle switch must also be of the "throw the stick back and forth" kind. Which a light switch basically is.
you can just use a toggle switch,,,you need a relay capable of the amps it takes for the starter.it would connect between the starter and the battery,then you would need a toggle switch preferably a momatary toggle switch to activate the relay.
how to replace window toggle switch 1999 buick century
Synonyms for toggle: adjuster, dial, knob, on/off, power switch, switch, tuner, push button
If your theft light keeps blinking while driving, chances are you have accidentally hit the toggle switch underneath the dash. Find the toggle switch that is located near the panel and click off the button.
Single pole toggle switch.
Overdrive switch is located on the gear shift stick, just below the handle. You could toggle with your right thumb to see if the O/D light comes on when pressed.
Yes! Find the wires going to the washer switch and just use a toggle switch in it's place. If you can't locate the wires, you can just run power straight to the motor from the toggle switch. I recommend you use a spring loaded on/off toggle switch, to make sure you don't accidentally leave it in the on position.
electric switch, electrical switch, control, controller
One of the main advantages of a push button over a toggle switch is there is less room for accidental engagements. A toggle switch can easily be turned on or off by accident and a push button has to be intentionally touched to turn it on or off.
This depends on the switch. A lot of older fireplaces have a millivolt valve with a toggle-switch sticking out. We usually remove the toggle switch and run the 2 wires that were connected to the toggle to a remote receiver box. This way any simple remote transmitter will act like an electrical toggle switch. Most receivers will recognize hundreds of thousands of signals so this is usually very convenient and takes about 3 minutes to turn a manual switch into a remote switch.