Home
Leaderboard
Wiki User
Answered 2007-01-07 13:13:21
There is a spring compressor made by SNAP-On, MAC, etc. I went to a body shop and borrowed one ; then the job is easy.
Your Answer
Still Have Questions?
Related Questions
How do you replace a hinge pin on a 1987 Chevy blazer?
break off the bottom bushing that hold door pin pick up on the door slightly use a hammer and screw driver to drive pin out and replace
Does the front transmission seal on a 1994 Chevy Blazer S10 4 wheel drive have to be put in from the front or from behind the front pump plate?
You carefully pluck the old one out, and use something like a peice of PVC pipe to hammer the new one in. It probably won't fix your problem though. Take the transmission to a shop, and have them do it for you, and at the same tiem, have them replace the pump's bushing. It requires disassembly of the pump, and special tools to replace the bushing.
How do you change a shifter cable in a 1996 Blazer?
The shifters main problem is always on the bushing. What you need to do is to loosen the bottles holding oneÊ end and the clip then remove and install the new bushing.
How do you replace a heater core in a 2001 Chevrolet Blazer?
how do i replace a heater core in a 2001 Chevrolet blazer
How do you replace dome light on s10 Chevy blazer?
how do you replace dome light in s10 chey blazer?
Replace heater core in 1997 Chevy blazer?
how to replace a heater core in a 1997 Chevy blazer
How do you replace the front driver side seat belt on a 2000 Chevy Blazer?
how do you replace seatbelt retractor on a 2000 chevy blazer
How do you replace blower motor on a 2001 blazer?
Location of blower fan on 2001 blazer
How to replace drivers side drivers side mirror on a 1997 Chevy blazer?
on a 1997 blazer, how to remove drivers side mirror under your handle to close the door is two 7mm bolt and behind your handle to open the door is a Philips screw and that plate behind it comes off then CAREFULLY remove the door panel trust me you don't want to break the plastic then you will see your mirror bolts and electrical wiring
How do you adjust door pins on 98 Chevy blazer?
If the door is not lining up correctly it is probably the pins and bushings are worn out. Replace the pins and bushings and the door should close correctly. Pin and bushing kits are available from your local auto parts store.
Where is blower motor on 2001 Chevy blazer motor and how do you replace it?
where is the blower motor on a 2001 chevy blazer
Where is the fuel filter on a 2002 Chevrolet trail blazer?
The fuel filter on a 2002 chevorlet trail blazer is near the drivers seat right on the side of the gas tank. Look in the middle near the drivers side
What is the process to replace the motor in an electric seat for the 1996 Chevy Blazer?
You dont need to replace the moter just pull the carpet up on the drivers side floorboard and there will be 3 oarnge wires all corroded and green rusted apart, replace the section you need to and your seat will work
How do you take the drive shaft out of a 1985 S10 blazer?
out a s10 short bed truck putting back does the front have to have the bushing by the seal can you take it off
How do you replace brake lines on 1998 blazer?
replace the line and fill and bleed breaks.
How do you replace the fuel pump on a 1991 Chevy Blazer?
pull the gas tank out and replace it
How do you replace fuel injectors on 2003 Chevy blazer?
How do you replace fuel injectors on 2003 Chevy blazer?Read more: How_do_you_replace_fuel_injectors_on_2003_Chevy_blazer
How do you replace drive shaft 2000 Chevy Blazer?
I have a leak on my drive shaft left front 2000 cheve Blazer I would like to replace the whole unit
What is cyclone herceo special move?
the answer is blazer slash
Need location of fuse block on 96 Blazer?
It is located on drivers side dash board. It is visible when you open the drivers door.
Where is the fuel filter on 1997 blazer?
Under the drivers side of the vehicle, inside the frame rail, aprox under the drivers seat.
What size tires does a 1989 Chevy blazer use?
look at the info sticker inside drivers door. My 89 blazer came with 31x10.5x15 from the factory.
How do you fix code po420 for Chevy s10 blazer?
P0420 = Catalyst Efficiency Below Threshold (Bank1). Sounds like you probably need to replace the Bank 1 (drivers side) Catalytic converter.
How to replace an AC compressor clutch on a 95 blazer?
sometimes there is a nut right in the center of the pully youcan loosen but sometimes it is pressure fitted on and you need a special machine to get it off.
How do you replace the heater core on a 1996 blazer 4door?
with your hands
Still have questions?
