It gives the receiving NIC time to realize a frame is coming and to know when the frame starts..
The purpose is the preamble signals to the receiving node that data is incoming and indicates when the data flow is about to begin. The SFD (start-of-frame delimiter) identifies where the data field begans.
1 byte for frame delimiter field in IEEE 802.3
preamble
The ethernet frame carries the IP (Internet Protocol) The Ethernet frame is made up of the following: 7 BYTE PREAMBLE 1 Byte "Start OF Frame" delimiter 6 byte destination address 6 byte source address 2 byte length or type 46 - 1500 bytes variable 802.2 or ethernet header and data 4 byte Frame Check sequence
ensuring that the data portion of the frame totals at least 46 bytes
IP, Ethernet, Frame Relay, ...IP, Ethernet, Frame Relay, ...IP, Ethernet, Frame Relay, ...IP, Ethernet, Frame Relay, ...
The preamble is a 64-bit (8 byte) field that contains a synchronization pattern consisting of alternating ones and zeros and ending with two consecutive ones. After synchronization is established, the preamble is used to locate the first bit of the packet. The preamble is generated by the LAN interface card.(http://docs.hp.com/en/98194-90053/ch02s03.html)
what are the ethernet frame parts The source and destination MAC addresses
The purpose of preamble is to give an introduction of the US Constitution. :)
The purpose was to guide others in life.The purpose of the preamble is to give a introduction to the us constitution.
Arpa encapsulation must be used to enable Ethernet II frame type on your Ethernet.
The purpose of the US Consitution is found in the Preamble...!!!