Want this question answered?
If installed correctly then yes you can on most systems. This depends on the spacing of your purlins, the type of metal used, the panel style used, the thickness of metal used, and the slope of the roof.
The wood at the edge of the roof is called the Fascia Board.
a gutter?
The facia board extends around the building just below the roof line.
The graft taken from the upper thigh area where the fascia is the thickest is called a tensor fascia lata (TFL) graft. This graft is commonly used in ACL reconstruction surgery due to its strength and thickness.
Most metal pipes thickness are 25 mm
Eaves- The roof edge from the fascia to the structure’s outside wall. In general terms, the first three feet across a roof is termed the eave.
Metals are conductive, but are not perfect conductors and so they have some electrical resistance. How the resistance of the metal is affected by "thickness" depends on what you mean by thickness. If the electrical current has to flow through a longer piece of metal, then the resistance of the metal to electrical flow would be greater. However, if you take that same length of metal and increase the area of the metal by increasing its "thickness", then the resistance of the metal becomes less.
Sheet metal thickness can be determined by measuring it. Several specialty tools are available to tell how thing the sheet metal is in actual measurement or by guage, a form of measurement that is used for various types of sheet metal thickness.
One of the pitches will have to "kick" out to the other so your Fascia all lines up.
The thickness of the drink made it hard to swallow.The metal sheeting is not the correct thickness.
Depending on your location, if the metal roof is going to be more durable and sturdier than your existing roof, you will need a permit. Also if the metal roof is going to heavier than your existing roof, it will require a permit.