You don't say what year this is, but all the later ones are computer controlled and there is no timing adjustment.
The timing marks on a Dodge 2.2 is next to the oil. This is under the hood.
whats the correct timing mark for a 1990 dodge ram pickup 318
The distributor is not timed with a timing light. The distributor rotor is lined up with the mark in the pick up plate when the crank is at tdc#1. The computer then does all timing from there.
diagram for timing marks on 1996 dodge intrepid 3.5
Start the engine and point the timing light at the timing marks. The flashing timing light will cause the timing mark on the harmonic balancer appear to be stationary and aligned with the timing marker. It should be lined up with "10 BEFORE." If not, turn the distributor until it is. Turn off the engine and tighten down the distributor hold-down. Unhook the timing light. Read more: How to Set the Timing on a 1974 Dodge 318 Motor | eHow.com http://www.ehow.com/how_7405118_set-1974-dodge-318-motor.html#ixzz2S9e9ResE
The timing mark is a line that goes across the harmonic balancer that should line up with the mark on the timing chain cover. It is on the drivers side on the bottom of the timing cover.
pin the engine on the flywheel. line the timing mark on the cam gear with the timing mark located on the timing cover. the mark on the cover is located at the top and is just a bump formed in the cover.
The timing mark is one the Harmonic balancer and the pointer is attached to the timing cover. Roll the motor over to the timing mark, the be sure and mark the number one plug {marked on the intake manifold} the position of the rotor pointer on the distributer.
diagram of timing marks 2c engine toyota
The fuel pam timing mark Scania 400 is on the engine.
A timing mark is usually a white line on the timing belt to sync the firing of cylinders in an engine. You can see this line when the engine is turned off or with a timing light also a strobe light when the engine is running.
The timing on a 1997 Dodge Ram is not set with a timing light. The distributor rotor is lined up with the mark on the pick up plate when the engine is at tdc to set base timing. The timing is then fine tuned with a scan tool. The scan tool is used to set it exactly to 0 degrees.