answersLogoWhite

0

dnt knw

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Mumbai university working hours?

11pm to 2pm and lunch timing wil be 1pm to 1.30pm.


What is the normal human sleeping and working timing?

8 hours


How do you know when your timing belt has stopped working?

Car Doesnt Start


Can you still drive a 1998 mercury mystique if the cam timing solenoid is not working?

yes.


What is the cause of bogging out when I accelerate in a 1977 Chevy El Camino?

Weak fuel pump? Fuel filter? Air filter? Sloppy timing chain Timing not adjusted properly Vacuum advance not working? Accelerator pump in carb not working?


Why does your 1963 Plymouth valiant hesitate at launch?

Could be, Accelerator pump in carburetor is not working, (rebuild carb) Timing is off, (adjust timing) Vacuum advance not working, (replace vacuum advance unit) Points are in need of replacing or adjusting,


How do you know if your vtec is working?

If the variable timing electronic control is not working the engine will not run, or will perform poorly in either low or high rpm.


What is the speed post timing in general post office on Saturdays?

POST Timings on Weekdays : 08.30am to 03.30pm POST Timings on Saturday : 08.30am to 12.00pm


What should your timing on a 350 with air gap manifold and a Saturday night special cam be?

For a 350 engine equipped with an air gap manifold and a Saturday Night Special cam, a good timing setting would typically be around 12-16 degrees of initial timing with around 34-36 degrees of total timing. It's important to ensure that the total timing is reached by about 3000 RPM to optimize performance. Additionally, fine-tuning may be necessary based on your specific engine setup, fuel type, and driving conditions, so consider making adjustments while monitoring engine performance.


How does skateboarding relate to maths?

working out speed and distance (timing) before jumping onto a rail... idk


Is wwwinheritanceforumscom working I can't gain access to it?

i get server not found appearing today but yesterday it was just timing out


I had the thermostat radiator cap and radiator replaced on a 2001 Mitsubishi galant and it still overheats sitting at idle and while driving Any ideas on what the problem is?

have the engine timing checked. if the timing is wrong the engine will overheat, are you loosing coolant?is the fan working, is the water pump working?