0
What should your timing on a 350 with air gap manifold and a Saturday night special cam be?
For a 350 engine equipped with an air gap manifold and a Saturday Night Special cam, a good timing setting would typically be around 12-16 degrees of initial timing with around 34-36 degrees of total timing. It's important to ensure that the total timing is reached by about 3000 RPM to optimize performance. Additionally, fine-tuning may be necessary based on your specific engine setup, fuel type, and driving conditions, so consider making adjustments while monitoring engine performance.
What else can I help you with?
1979 305 sbc stock what is the proper timing THKS?
PROPER TIMIMNG SHOULD BE LISTED ON THE INTAKE MANIFOLD PROPER TIMIMNG SHOULD BE LISTED ON THE INTAKE MANIFOLD PROPER TIMIMNG SHOULD BE LISTED ON THE INTAKE MANIFOLD
What should the timing be set at on a Chevy 350 with an edelbrock performer cam and manifold?
10-12 degrees
What is a map sensor in 1997 Chevy cavilier?
map stands for manifold absolute pressure it records manifold pressure and adjusts fuel and timing acordingly. it should be located on the firewall. hope this helps.
Does a 1992 325i have a timing chain or belt?
The e36 M50 has a timing chain. The e30 has a belt. Black plastic intake manifold = Chain Metal intake manifold = Belt
What is the timing of Kalina University on working Saturday?
dnt knw
How do you test a knock sensor to see if it is bad?
Knock sensors detect detonation ( knocking ) by reacting to the ping by retarding the ignition timing so you will need a timing light for this. connect the timing light and locate the knock sensor, ( many are on the intake manifold ) now use a metal object to tap ( not too hard and not on the sensor itself ) on the intake manifold ( light tapping should suffice ), if the sensor is functioning you will see the timing retard. If the timing does not retard you will need to check voltage across the terminals of the knock sensor connector.
Do you have to remove timing belt to change intake manifold gasket on 3.4?
No absolutely not...
Why does the exhaust manifold glow red hot?
Advanced timing can cause that to happen
Where is the locaion of the knock sensor dodge neon?
if you would stand in front of the engine (in front of the timing belt),it should be on the left side of the engine block under the exhaust manifold
Exhaust manifold passenger side 5.9 gas so hot eating up o2 sensors and cats?
It should not be doing that. There is something amiss. Probably the timing. Have a mechanic check it.
Why does the Manifold over heat?
The manifold has no way of overheating, it's a piece of metal if its glowing red then the exhaust may be plugged up, or the engine timing is retarded, or you have an ignition misfire. Everyone should have a manual for their vehicle (parts store or dealer), and a local library should have professional shop manuals available in the REFERENCE section for free.
Where is the timing chain on a 2006 Chevy Cobalt located?
The timing chain is located on the left side of the engine, to access it you will need to take off the manifold cover.
