It is called the plus sde and the other is called the minus.
The top part of a shoe is called the upper
This is called wavelength.
The crest.
The distance from the rest point to the top is called the amplitude. The top of the wave is called a crest and the bottom of a wave is called a trough.
It is called a halter top
That is called a cupola.
The top of a battery is called a carbon rod, which is on the positive terminal.
helix
Numerator
The top bit of the centre is called the Northern Territory, the bottom bit is South Australia.
The top bit, called a fret board on a guitar
It is were the sea erodes right through the land leaving a bit on each side and a curved bit at the top but sometimes the top bit falls into the sea and then the bits that are left are called a stack.
ice tail
You get them in Early Poptropica island, then you go right, then you go down the well and you jump to the top left ledge! Hope I helped you a bit!
Get a flashlight and look into the fill holes in the top of the battery. See those plates in there? Slowly add acid to each fill chamber until the acid barely covers the top of the plates. Go do something else for 5 minutes, and recheck the acid level. You will find it dropped a bit. Add more acid until the plates are barely covered. Put your fill caps on and place the battery on a battery charger. After this, you top the battery up to the top of the plates with DISTILLED WATER ONLY. There you go. Done.
the head If you mean a drummers drumstick it is called the tip.
I am assuming you are talking about cleaning the top of a lead-acid battery. I am also assuming that the "clamps" are the battery terminals that clamp onto the battery posts with a pinch bolt. If this is the case then... Yup, In fact we do it all the time. There is bound to be a bit of "stray" voltage between the battery posts when the battery top is wet, however it will be pretty minimal. Just be sure to that no baking soda gets inside of the battery cause it will neutralize the electrolyte (acid) in the battery. Thouroghly rinse and dry the battery top afterwards and coat the terminals with a good corrosion prevenative spray. Hope this helps.