answersLogoWhite

0


Best Answer

Torque is 26, 41, 52 ft/lbs. (second pass), 52 ft/lbs (final)

User Avatar

Wiki User

βˆ™ 12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the torque settings for a 1995 1.6 Geo Tracker head bolts?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What are correct torque settings for 1995 Mercedes e420 wheel nuts?

What are correct torque settings for 1995 mercedes e420 wheel nuts?


Torque specs for a 1995 Subaru impreza 2.2 head bolts?

Torque specs for a 1995 subaru impreza 2.2 head bolts?


Ford Escort 1995 engine torque settings?

Get a manual.


What are the Torque specs for 1995 Toyota thermostat housing?

The 1995 Toyota Tacoma thermostat housing torque specification is 40 pounds. The amount of torque on the thermostat housing bolts is not that important. You basically do not want to break the thermostat housing bolts.


What are the head bolt torque specifications for a 1995 Chevy S10 2.2?

The cylinder head bolt torque specs for a 1995 Chevy S10 2.2L are as follows: 1st: Torque the long bolts to 46 ft lbs, short bolts to 43 ft lbs 2nd: Turn all bolts an additional 90 degrees


What is the torque specs for 1995 Neon oil pan bolts?

9 ft lb


What is the torque spec for a 1995 Cadillac 4.9 liter rocker arms?

torque specs on the bolts that hold the rockers on a 4.9 cadillac motor


What is The torque for cylinder head bolts on a BMW 316i 1995?

316i engine code 16 4E2 Head bolts must be renewed Torque settings stage 1. 30Nm stage 2. + 90 degrees stage 3. + 90 degrees Tightening sequence 7 5 1 3 9 10 4 2 6 8 Bolts 7 & 10 are the flywheel side of the engine


Virago 1995 250 torque settings for rear swing arm bolt?

ayo What’s this question?


What are the head bolt torque specs for a 1995 Pontiac 3.1 liter head bolts?

What is the head bolt torque for a 1997 chevy lumina four cylinder?


What are the torque settings for an rover 214 5E 1994 1995 series?

I believe its the same as the 1.1, torque all bolts up to 28Nm, then starting from the middle and working outwards diagonally across the head, angle tighten each bolt by 90 degrees. Leave for 5 minutes then angle tighten by 90 degrees once more. I used these settings on a 1995 214 when replacing the head gasket and the car is still going strong! Hope this helps. DUBYA.


I have 1995 4x4 Geo Tracker with a bad auto transmission will auto transmission out of 1998 4x4 Geo Tracker fit in 1995 Geo Tracker?

i have 1995 4x4 geo tracker with a bad auto transmission will a auto transmission out 1998 4x4 geo tracker fit in 1995