From the manual it says to do them from 70-90 in lb. when i did it today we broke the outside bearing cover bolt at about 50 or 60 in lb. It is smaller than the rest and might have a different spec not listed in the manual so be careful when doing those outer ones
13 ft/lbs - 16 ft/lbs
Torque specs for a 1995 subaru impreza 2.2 head bolts?
Engine code 176A7.000 camshaft carrier/cap torques M8x1.25 = 20Nm M8 = 10Nm
the correct torque for these bolts is as follows: 96lbs
Torque specs for main bearing
The 12mm bolts on each end bearing cap should be torqued to 14 ftlbs. The 10mm bolts on the bearing caps in between should be torqued at 8 ftlbs. This is from the Mitsubishi 6G7 overhaul manual for the DOHC engine. next time post your engine, if is turbo or not... that will help
Front caliper mounting bracket bolts torque to 57ft-lbs Front caliper pin bolts torque to 27ft.lbs Rear Caliper mounting bracket bolts torque to 38ft-lbs Rear caliper pins torque to 15ft-lbs
Torque settings for main bearings and big end bearings
what are the torque for camshaft and cylinder head bolts please
The torque should be around 11 ft-pounds
Using new bolts, torque the front hub/bearing assembly to 96 ft-lbs.....
hi i am looking for the torque settings for a proton gen 2 cylinder head bolt and crank shaft bolts both big ends and main bearing bolts