100 ft/lbs
The torque spec is at 95 ft/lbs. Per cycle center of denton.
50 ft lbs
72.5+tighten to align cotter pin hole
95-105 ft lbs.
unadjust the rear parking break.... or the rotor is rusted to the axel.
The torque for the rear axle nut on the 1996 Magna is 63 ft-lb. That's from the Honda Service manual. Hope this helps you out.
39hp and 36ftlbs of torque.
No, not just bolt on and go, get the rear spacer from the gsxr wheel and install rear wheel with that spacer and remove te stock one that's on the Busa, then mill .125 off the rear brake caliper hanger so it tightens to the wheel.. as for the front you'll need the gsxr 1000 rotors too, as well as spacers from the gsxr for them to fit a Busa.
35mm
173 ft/lbs
68nm. If you do the math, that comes out to 50.1 foot lbs. Hope you ate your Wheaties!
Local Ford dealer wanted $285 to replace both rear axel seals on a 2005 Ford Mustang GT (Jan 2012).