0
What is the torque spec for the rear axle nut on a 1992 Plymouth Voyager?
Bjauto
This is the stub, with the inner and outer bearings in the brake drum, right? If so, tighten only to about 10 or 12 ft-lbs. The manual says to then back off the nut until only finger-tight, but I feel that may be too loose. Turn the drum while tightening. The goal is to allow the drum to turn freely but without any play. Check again once you have the wheel back on and can rock it back and forth to check for play.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What is the proper torque spec for rear axle nut for a 1992 Plymouth voyager?
175 ft/lbs
Torque specs for axle spindle nut for 1995 Plymouth grand voyager?
If front axle of front-wheel drive, it's about 200 ft.-lbs. If back, not all-wheel drive, see question on rear axle of 92 voyager.
What is eatx in Plymouth Voyager?
Electric automatic tran axle.
What are the 1992 Saturn sl axle torque specs?
Axle torque specs are as follows: Axle nut torque..............148Ftlbs
How much does it cost to fix an axle seal?
How much it cost other fix a trans axle on plymouth voyager
What is the torque specification for axle spindle nut on 1993 Voyager?
180ft.lb (244Nm)
How do you replace the drivers side axle on a 1992 Plymouth Voyager 2.5 ltr?
You need a 22mm soket and a long pry bar to do this job. You better watch it done the first time.
Where is the vss located on a 1993 Plymouth Voyager?
Top of the housing on the transmission where the right axle shaft goes.
Your 98 Plymouth Voyager gets stuck in 2nd gear?
check fuse inside fuse box trans axle fuse im not joking
Where is the speedometer sensor in a 1991 Plymouth voyager and how do i replace it?
It is in the axle shaft housing on the right side of the transmission. It is held in with one 10mm headed bolt.
What is the torque spec for the axle nut on a 1992 Chevy Silverado Pickup?
173 FT. LBS.
How many CV joints does a 1992 Plymouth acclaim have?
It has four cv joints, two in each front axle shaft.
