Here is a site with that info, and for a lot of other vehicles:
http://www.aera.org/downloads/Torque3.pdf
2003 sunfire
it is located inside of the oil pan. if you have low pressure and have high milage you could have bad crank bearing.
The Torque specs for a 1992 Jeep Crank with bearing caps is 80 ft./bls. You will need to check your chiltons.
38ft lbs
1996 pontiac sunfire 2.2 crank was moved but cam was not could the timing get out 180 degrees before i put it back together
on the 2.4 its to the left of the starter above the oil filter
on the back of the motor wright below the crank sensor
40 ft. lbs
Mains 85------- rods 45
I've been trying to find this out for my Pontiac. The best I got was the answer at eHow.com. Here's the link http://www.ehow.com/how_11205_convert-power-windows.html Hope that helps -KV
it could have a bad air filter or the fuel is clogged some where. or the batt could be going bad.
hi i am looking for the torque settings for a proton gen 2 cylinder head bolt and crank shaft bolts both big ends and main bearing bolts