Look in a Haynes repair manual relative to your vehicle
i do not have any manual
torque specs on head gaskets 1988 toyota corolla 4A-F
The Toyota Corolla 1.6 liter engine cylinder head bolt torque specification is 150 pounds. The head bolts should be torqued in 50 pound intervals.
216 nm
1991 toyota camry head bolts torque specs
There are torque specifications for every bolt in a Toyota Corolla 1.3 L engine. The head bolt torque specifications is 70 pounds.
There are 2 different torque specs. for different bolts, some are 96in-lbs. others are 18ft-lbs. see link below it has a diagram show which are which.
The torque specs for a Toyota Camry cylinder head is 60 pounds for the inside bolts and 50 pounds for the site bolts. The cylinder head bolts should be tight from and to end alternating.
The torque specs for the head bolts on a 1997 Toyota Corolla goes in three simple steps: step one- tighten the bolts in the the correct order to 22lbs step two- in the same order, turn each bolt 90 degrees step three- go through and again in the same order turn each bolt in an additional 90 degree.
98 toyota tacoma head bolt specs
Torque as follows 53-63 ft/lbs. in 3 steps
The 1995 Toyota Tacoma thermostat housing torque specification is 40 pounds. The amount of torque on the thermostat housing bolts is not that important. You basically do not want to break the thermostat housing bolts.
The torque specs and pattern on the head bolts for a 1991 Toyota pickup with a 3.0 EFI is 50 foot pounds per bolt. The pattern is 4,5,6,3,7,2,8,1 with 1 being at the front of the engine.