Want this question answered?
The difference between the two transformers is the coil ratios between the primary and secondary windings. A transformer that increases voltage from primary to secondary has more secondary winding turns than primary winding turns and is called a step-up transformer. Conversely, a transformer with fewer secondary windings does just the opposite and is called a step-down transformer.
There are various ways in which you can connect a three-phase transformer's primary and secondary windings, or in which you can connect three single-phase transformers to create a three-phase transformer bank. For example: wye-wye, wye-delta, delta-delta, delta-wye, etc.For each connection, there is a natural phase shift between the primary and secondary line voltages. This is called the angular displacement (or 'phase displacement') of the transformer connection.If you wish to parallel two three-phase transformers, or two three-phase transformer banks, then their angular displacements must be the same (there are also other requirements not relevant to this answer).A vector group is a method of specifying a three-phase transformer (or transformer bank) method of connection and its angular displacement. Transformer connections from the same group can be paralleled. Those in different groups cannot
fly-back transformer.
The device used to increase or decrease the voltage of an electric circuit is a step up transformer or a step down transformer respectively. A Variable Resistor
The vertical rows on the periodic table are called groups.The vertical rows are called periods and the horizontal columns are called groups.
Transformer has windings
Transformer in Hindi is called "ट्रांसफ़ॉर्मर" (pronounced as "transformer"). It is a device used to transfer electrical energy between two or more circuits through electromagnetic induction.
A winding is the name given each of the coils wound around the transformer's core. A basic transformer has two windings, termed the primary winding (connected to the supply) and the secondary winding (connected to the load).
You need two windings because that is the purpose of the transformer - to convert one voltage into another. If there were only one winding, it would be an inductor, or a special case called an autotransformer, but that is still "sort of" two windings.AnswerThe major advantage of a two-winding transformer (a 'mutual transformer') over a single-winding transformer (an 'autotransformer') is that a two-winding transformer provides electrical isolation between the secondary and primary circuits. This is very important for safety reasons and there are many circumstances in which the use of an autotransformer is not permitted.
pixal
The incoming voltage from the source to the transformer is called primary voltage.
The difference between the two transformers is the coil ratios between the primary and secondary windings. A transformer that increases voltage from primary to secondary has more secondary winding turns than primary winding turns and is called a step-up transformer. Conversely, a transformer with fewer secondary windings does just the opposite and is called a step-down transformer.
the solar transformer is called soundwave.
There are two groups of animals that are called a bed. Oysters and clams are both called beds when they are in groups.
The flutes and the reeds.
Injecting power into the higher voltage winding of a transformer will make it act as a step down transformer; injecting power into the lower voltage winding will make it act as a step up transformer. A transformer can be used both ways.
There are two types of transformers:- 1. Step-up transformer & 2. Step-down transformer. A transformer used to increase the voltage is called Step-up transformer. A transformer used to decrease the voltage is called Step-down transformer. Uses of step-up transformer:- in power supply stations, in picture tubes of TV, computer monitors, halogen lights, etc. Uses of step-down transformer:- in supply of electricity to homes, in the power supply to the low voltage devices like radio, music systems which are run by AC mains.