Want this question answered?
what is used to measure dry sand
Dry ounces are not compatible with milliliters. There is no conversion factor. You wouldn't ask how many inches there are in a pound, would you? It's the same idea. A dry ounce is a unit of weight, whereas the milliliter is a unit of volume.
Once again, no conversion is possible, because a dry pintis a unit of volume -- space -- whereas a pound is a unit of weight. A dry pint of wheat will not weigh as much as a dry pint of, say, iron filings.
That depends on the type and grade of the sand
Sand
unit wight sand
Dry Sand 1.44 to 1.6 Tons/ Cu.m
Sand, wet - 1920 kg/m³ Sand, wet, packed - 2080 kg/m³ Sand, dry - 1600 kg/m³ Sand, loose - 1440 kg/m³ Sand, rammed - 1680 kg/m³ Sand, water filled - 1920 kg/m³
The weight varies; but if it's dry sand, the cubic meter will weigh around 1500 kilos.
The density of sand varies depending on what minerals the grains of sand are made of, and wet sand is denser than dry sand. As a rough rule of thumb, a litre of dry sand weighs about 1500 grams.
Dry Metric Tonnes
Anyone who has dug a shovelful of wet sand and a shovelful of dry sand will tell you that the wet sand is quite a bit heavier than the dry sand. Dry sand is composed of individual particles with air in the spaces between grains. When you add water to a bucket of dry sand, the water replaces the air. Although the bucket is already full of sand, you can pour in quite a bit of water, adding that much more weight. If you have a choice of which bucket to carry, pick the bucket of dry sand every time!
basically it's sand like substance that you put in a tub and your chinchilla rolls in it. it how it stay dry and stays clean. you don't want to get your chinchilla to wet it can die if it doesn't get dry quick enough.
The Sand Cone Method is a sand replacement method for determining the field unit weight or the in-situ density of natural or compacted soil. There are three standard procedures used for determining this weight, including the Sand Cone Method, Rubber Balloon Method and the Nuclear Method. In the Sand Cone Method, as done in this lab, a hole is excavated in the area where the soil has been compacted and the dry weight of the soil can be obtained by determining the weight of the moist soil and the moisture content. The volume for the hole excavated is calculated by reintroducing the sand into the hole and then the dry unit weight of compaction is calculated by dividing the dry weight of the soil by the volume of the hole. This test method is applicable for soils without appreciable amounts of rock or coarse materials in excess of 1 1/2 in. (38 mm) in diameter. The main application of this test is the cases like embankment and pavement construction, this is basically a quality control test where a certain degree of compaction is required. This test is also used in stability analysis of embankments and slopes, for the calculation of pressure in underlying strata for settlement problems and also design of underground structures.
Clean quartz sand weighs 80-125 pounds per cubic foot depending on degree of compaction and moisture content. Usually folks figure sand at 100 pcf. There are 27 cubic feet in a cubic yard. So to continue the answer the previous poster made... Using the 100 pcf average weight for sand, and that there are 27 cubic feet in a yard, then 1 yards is equal to 27 cubic feet and at 100 pcf, the total weight is 2700 lbs, or 1.35 tons.
I wait till it's totally dry (3-4 hours) then sand it off.
You need 4.27 cubic feet. Weight in pounds is deceptive for sand depending on how wet or dry the sand is.