The Auxiliary Carry (AC) flag in the 8085 indicates a carry out of the low order 4 bits of an operation, more specifically that the low order 4 bits are greater than 9 (10012). The AC flag can thus be used to facilitate decimal arithmetic.
there are 5 flags of intel 8085 are: Carry flag(CY), parity flag(P), Auxiliary Carry flag(AC), Zero Flag(Z), Sign flag(S).
INR affect the carry flag.
Carry
The 8085 microprocessor has 5 flags: 1. Zero flag: The zero flag is set, when the ALU operation results a zero . 2. Carry flag: If an arithmetic operations results in a carry, this flag is set. 3. Parity flag: This flag is set, when an arithmetic or logical operation results in a data, which has even number of 1s. If otherwise, it is reset. 4. Sign flag: After the execution of an arithmetic or logic operations, if D7 bit of the accumulator is 1, it indicates a negative number and this flag is set. If otherwise, it is reset. 5. Auxiliary Carry flag: used for BCD Operations, During the BCD operations, if D3 bit producing the carry then the AC bit set as1, otherwise the bit is 0. 6. Carry Flag: when a carry is generated by digit D7, then the carry flag set as 1, otherwise the bit will be 0.
Processor status word ( PSW ) in the case of 8085 refers to the collection of the values of the flag register and accumulator. It is used with the command push: PUSH PSW With this command, the proccessor saves the value of accumulator (A) and the values of the flag bits to the stack.
Flags are microprocessor dependent. ie flags are different for different microprocessors. Flag represents the status ( & Type) of the operation performed. Ex: In terms of 8085 we have 5 flags : Zero, Carry, Ac Carry, Parity, Sign Flag register is of 8 bits in this case. These flags can also be used for logic implementation.
yes
The flags are testable conditions that are set after many arithmetic or logical instructions to indicate something about the result of the result. For instance, the Z flag means the result is zero, the N flag means it is negative, the O flag means a signed overflow occurred, the C flag means an unsigned overflow occurred, and the P flag means an even number of bits is set in the result. You can use the various flag testable jump instructions, such as JZ or JNZ to test the flag after performing an operation that sets or resets the flag.
The delay is calculated in 8085 by making the use of formulas. Because of the complexity of the mathematical operations a calculator may also be required.
8085 is a microprocessor designed by Intel
3MHz happens to be slightly less than the maximum CLK speed (3.125 MHZ) of the most common variety of the 8085 (8085AH).
It is the oldest NATIONAL flag still in use - it is not the oldest flag.