About 60 USD or so
Tarja Laitinen has written: 'Thiosulfate pitting corrosion of stainless steels in paper machine environment' -- subject(s): Corrosion, Papermaking machinery, Stainless Steel, Steel, Stainless, Thiosulphates
Corneal Ulcer.
S. Mat has written: 'Pitting and stress corrosion cracking of stainless steels in sour environments'
No. If it minor pitting, honing the cylinder may be enough. If it is deep, it will need to be bored and an oversize piston used or the cylinder can be sleeved.
The life span of stainless steel depends on the type of stainless steel, the environment it is located, and the surface treatment. There is micro-pitting that will occur with out effecting the structural integrity of the steel but will tarnish the 'stainless' appearance. If the environment is free of heavy moisture and corrosive chemicals 316 stainless steel will last 1200 years with out significant decay.
non pitting
Iron, Chromium, Nickel, Steel, Nitrogen, and Molybdenum Iron is the main element of stainless steel, Chromium is a metal that stalls the oxidization of iron. Nickel increases the corrosive resistance further and can protect stainless steel from rough usage and harsh environmental conditions. Pitting or scarring is avoided by adding molybdenum to steel.
Pitting corrosion generally happens in an oxygen deficient environment where the metal is surrounded by an ionic solution with chloride, bromide, or fluoride ions. A scratch in the metal under these conditions does not allow the metal [such as stainless steel] to reform the thin oxide layer which would normally protect the surface.
Pitting Corrosion is the localized corrosion of a metal surface confined to a point or small area, that takes the form of cavities. Pitting is one of the most damaging forms of corrosion. Pitting factor is the ratio of the depth of the deepest pit resulting from corrosion divided by the average penetration as calculated from weight loss. This following photo show pitting corrosion of SAF2304 duplex stainless steel exposed to 3.5% NaC1 solution.Pitting corrosion forms on passive metals and alloys like stainless steel when the ultra-thin passive film (oxide film) is chemically or mechanically damaged and does not immediately re-passivated. The resulting pits can become wide and shallow or narrow and deep which can rapidly perforate the wall thickness of a metal
condition of the Colt has a great deal to do with value. what condition is the finish ?? is the bore shinny, dull, pitted ??? Any rust or pitting on frame ??? Length of barrel.. Send me a picture that I can see condition.....................
Clear water will "cavitate" (allow bubbles) causing pitting and eventually resulting in pin holes in cylinder liners.
Pitting potential is the potential where the pitting start and this is noticed when the current is suddenly increased that also mean below this value, now pitting corrosion will initiate Many parameters can effluence the pitting potential such as Temperature, halides ions, surface finishing of the alloy and also state of the electrolyte , is it flowing or stagnant.