answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What is the valve clearance exhaul and intake on a 1998 Mitsubishi pickup 4d56?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you know when to replace the fuel pump on a 1988 Mitsubishi pickup?

you have to remove the studs, or remove the entire intake manifold! when you do finally get it off replace the studs with bolts.


Is it possible to swap a 4g63 into a 1988 Mitsubishi pickup 2wd?

yes it is


Where is a Mitsubishi pickup located?

Mitsubishi pickup can be found when one goes to any Mitsubishi dealers. One can get bargain deals when one visit used car shops. One can check online at sites like Auto Trader for price comparison and make a good choice.


A wiring diagram for a 1986 Mitsubishi pickup?

coil and disribuitor elecrtic wireing?


What is the average gas mileage of a Mitsubishi L200 Warrior pickup?

The average gas mileage for the Mitsubishi L200 Warrior pickup truck is 34 mpg. Actual mileage will vary depending on the driving conditions and the mechanical condition of the vehicle.


Where is the data link connector located on a 1988 Mitsubishi pickup truck?

The 1988 Mitsubishi pickup truck data link connector is located on the bottom of the drivers side dashboard. The gauge link connector will be to the left of the steering column.


What is the clearance of the oil pump for a Chevy 350 engine?

we measured pickup-to-oil-pan clearance with a lump of Playdough. Shoot for around 3/8 to ½ inch


What is the Valve clearance specs for a 1984 Mazda B2000 pickup?

Also,do you adjust them warm or cold?


Where is the intake air temp sensor located on a 1991 Nissan pickup?

The intake air temperature sensor is built into the MAF sensor on a 1991 Nissan pickup. It is between the air box and the throttle body.


Where is the knock sensor located on 2005 Chevy pickup 5.33L?

There are 2 of them, Thay are under the intake manifold. You will have to remove the intake to get to them.


If you have a pickup truck that weighs 4000 pounds when it was new you are modifying it to increase its ground clearance when you are finished?

Irk


Where is the theromstat on 1985 Nissan pickup?

follow the top radiator hose to intake