0.12 inlet 0.14exhaust
No. The Yamaha YBR 125 has a four-stroke engine.
Intake valve: 0.05 - 0.10mm (0.002 - 0.004inch) exhaust valve: 0.08 - 0.13mm (0.003 - 0.005inch)
yamaha ybr 125, How much is the fuel consumption per 01 Litter in kilometer ?
Motor oil
Valve clearances on a cold engine for the YBR 125ed when measured at top dead centre on the compression cycle are :- 0.08 - 0.12mm for the inlet 0.10 - 0.14mm for the exhaust
because maybe your valves are bent and your stem seals are leaking which means oil is going into the head thus making smoke in the exhaust. or your valve clearances are out.
Yamaha YBR 125 is available on E-Bay and also at local Yamaha retailers all over the world. Used bikes may be for sale locally. You can try to advertize for one, the price may be lower from a private person than from a used bike dealership.
The airport code for Brandon Airport is YBR.
well you should drink it in school coz the teachers willney let yah drink dah fizzy stuff Lol mee Gonneee Tah tah :) xx YBR YMR
According to SOWPODS (the combination of Scrabble dictionaries used around the world) there are 2 words with the pattern ---YBR-D-. That is, nine letter words with 4th letter Y and 5th letter B and 6th letter R and 8th letter D. In alphabetical order, they are: dihybrids polybrids
According to SOWPODS (the combination of Scrabble dictionaries used around the world) there are 1 words with the pattern -O-YBR-D. That is, eight letter words with 2nd letter O and 4th letter Y and 5th letter B and 6th letter R and 8th letter D. In alphabetical order, they are: polybrid
It's outside the scope of this answer to go into the theory, but a 3 phase motor by convention normally rotates anticlockwise when viewed from the 'driven' end. To check phase sequence, the usual method is to use a phase sequence indicator. Originally these were like a miniature three phase motor encased in a hand-held device. If the flying leads were connected RYB, BRY, or YBR, the disc in the psi would rotate anticlockwise. If the flying leads were connected RBY, BYR, or YRB the disc would rotate clockwise. Nowadays, the mechanical aspect of the phase sequence indicator has been repalced with solid state devices that indicate on one of two leds if the sequence is c/w or ac/w. To check phase sequence you look for which phase out of the three phases peaks first. You could probably put each phase on an oscilloscope and see which one peaks first. Phase sequence is usually taken as positive anticlockwise from the reference voltage ( the phase that peaks the first).