95 in-lbs.
If you are asking because of your valve cover leaking oil, there was a recall on that year valve cover gasket.
the chiltons manual for my 1990 B150 dodge ram van states 80 inch pounds. For a Ram 2500 with 5.9L Cummins 12 valve engine. The torque should be 18ft-lbs or 24Nm.
I was told 7lbs
6-8 lb/ft.
The 2001 Nissan valve cover bolt torque specification is 45 pounds. The valve cover bolts should be torqued in 15 pound intervals.
The 2001 Mitsubishi Montero Sport 3.0 liter engine valve cover torque specification is 40 pounds. You do not want to over torque the valve cover bolts, as you may ruin the valve cover gasket.
its on the back of the fuse cover
The 2000 Mazda 1.8 liter engine valve cover torque specification is 45 pounds. The valve cover bolts should be torqued in 15 pound intervals.
For all 1992 Dodge Dakota V6 andV8 engines:All of the water pump bolts are to be torqued to 30 ft. lbs.For 1992 Dodge Dakota 4 cylinder engines:Upper bolts are torqued to 21 ft. lbs.Lower bolts are torqued to 40 ft. lbs.Waterpump housing-to-cover bolts are torqued to 105 inchlbs.
35 ~ 46 Foot pounds of torque. Pressure plate bolts.
The engine cylinder head cover nut has a torque of between 7 to 9 foot-pounds. This measurement specification also applies for the '80, '81, and '82 Z50R builds.
95 ft inches of torque , make sure it is in ft inches of torque and not ft lbs.