0
What is the vibration on your passatt 2002.The exhaust has being checked and is ok. It is coming from the front of the car?
Wiki User
∙ 15y ago
A number of possible reasons. There could be damage to your tire rims. Your tires could require balancing. Why would you check the exhaust system if the vibration is coming from the front?
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Will rims off a 2006 passatt fit a 1999 passatt?
yes they will they have the same bolt hole pattern
Cars made with the letter p?
Passatt, Polo, Porche.
Where is the transmission dip stick for the 2002 passatt?
There isn't one, you check it through the dashboard.
Where is the brake vacuum pump on a 2003 vw passatt?
how to change brake vaccume pump on a 2003 vw passat
How do you re set the oil light on a 1995 passatt estate?
Add oil to engine until level correct on stick.
Will your vw mud flaps fit the front and rear of your vw passatt?
yes it will but only if you remove the engine and burn it inside a guy Fawkes bonfire
How do you wind back the caliper on a vw passatt 2007?
you can buy a tool from car shop just for the job. you place it between the brake piston and in the caliper and twist pushes pistonsback and lets you fit new pads costs about £20.00 but worth it hope this helps
Why would your car make a whining noise when it's going in reverse?
this is normal and nothing to worry about. Almost all vehicles make a whining noise in reverse Ford Mondeo's sound the same reversing as they do going forwards no whining also VW Passatt i think the Golf's are the same also maybe modern technology has improved this. probably bad enough listening to your wife whining you can do without your car doing it.
Is top dead centre used when replacing the timing belt on a vw passatt 1.9 tdi pd?
I recently "shed" an alternator belt which trapped itself between the cam belt and bottom pulley sending the cam timing out. Stripping and re build I was annoyed to find no bottom pulley TDC mark. VW stated I needed to take the car in. Examination of the removed items showed that the bottom toothed pulley has a "pimple" machined ito its face. That pimple lines up with an enlarged hole in the "auxiliary belt pulleys. If you look at the rear of those pulleys, there is a very fine notch machined into them. Carefully line the bottom pulley up with that "notch" at TDC, together with the cam belt timing being set where it needs to be, (use a 6mm bolt/drill through to the head to lock). replace the belt and tension. Rotate the engine on a "spanner" to ensure no contact. Then test. It worked for me...!
