its 12 v
5lb battery
yes if the battery is the same voltage, wire should be used to do this.
Inside a 12 volt battery charger, one of the main components is a transformer used to lower the supply voltage to 14 VAC. The other main component is the diode bridge. It is a full wave bridge network which uses four diodes for voltage rectification. The open circuit output of the battery charger is about 13.8 VDC. So, no a battery charger is not a rectifier but it used the process of rectification in its operation.
The number of cells in a battery determine the battery's voltage. Different types of batteries have different cell voltages. The cell voltage is dependant on the reactive metals used. A typical car battery will have six cells. Because a typical cell voltage has a source voltage of approximately 2.0 volts, this makes a car battery produce a voltage of 12 volts.
there is only one clutch and that is on the left handle bar
Plastic, fiber glass, rubber and steel
All Harley Davidson motorcycles have used a 12 volt battery since 1965. Prior to 1965 they used a 6 volt battery.
It is a meter with a high wattage resistor connected parallel with the meter that drains power from the battery while it is measuring the voltage it is used to test the condition of the battery if the condition is good there will not be a large voltage drop while testing the battery
To charge a battery, the charger voltage must be higher than the battery voltage. If a AA battery (or any other) has a normal voltage of 1.2V the charger voltage must be at least 1.2V. The type of voltage supply and its current capability is immaterial. No, the charging voltage have to be larger than the battery voltage, to charge 2 AA batteries, that is 3 volt if connected in series, so a voltage of at least 4 volt is needed
If both batteries are of the same voltage (12 or 6) yes, you can use the charger. make sure that they are of the same voltage.
15.5 volts
7.4 volts.