Technically, a router can be flashed and custom programmed to run faster, and have higher wattage for WAN. I would not recommend doing this, as it may burn up your router and turn it into garbage if not done correctly. I have done this myself, and use it as a paperweight now. So the answer, YES it is possible but not recommended.
Wattage= current*voltage*power factor. Wattage=VI Cos(@)
Yes, wattage is wattage, is wattage, is wattage. "Power" is calculated in wattage. It equals the voltage times the current in amps. In a light bulb, the resistive filament will cause a certain amount if current to flow making the filament hot and producing light.
The wattage can vary depending on manufacturer, capacity, model, etc. The wattage will be stated on a label fastened to the boiler.
NO preamp has wattage or a wattage rating. The only wattage involved in a sound system comes from the POWER amp
Find the wattage rating on the dimmer controller. This is the maximum allowable wattage that the lamp in the fixture should be. Lamp wattage ratings under the rated dimmer wattage is fine but do not install a larger wattage lamp that is over the dimmer control's rating.
on the router then off the router your ios is install on the router then off the router your ios is install
wattage is nothing but power product of current and voltage p=v*i
Wattage, you mean power. Power = V * I. V - the voltage and I the current.
The wattage of bulb one uses in a bedroom lamp depends on several factors. If it is a lamp used for back ground lighting or a night lamp, one would use a very low wattage bulb. If it is for a bedroom reading lamp, one would want a stronger wattage. The biggest factor on deciding what wattage to use is the wattage suggested by the lamp manufacturer. All lamps are marked with recommend bulb wattage.
The wattage will depend upon the type of bulb and the number of lights on the string. It will tell you on the package what each bulb requires in wattage, so you only need to multiply that by the number of bulbs in the string. so, number of bulbs x wattage requirement for each bulb = wattage requirement.
It would be on your router. the PS3 does not have a router you have to buy one if you need a router