I've never come accross a striped screw. Makes me think of candy canes. I tell you what though, I've seen quite a few STRIPPED screws. Get an "Impact Driver" from your parts store (Or tool truck). It is a screw driver that you hit with a hammer in to the screw. The impact also causes the head of the driver to rotate while being pushed in to the hole. If all else fails get yourself some sharp drill bits.
yes its used to start off screw holes
A lug wrench is the tool needed to take a wheel off.
you take the screw off the carbarator.
take off the old one with a harmonic ballencer puller you can rent one at the tool rental store, there is a large screw holding the ballancer in place with a keyway, you losen the screw tell its almost off but not all the way and then you attach the puller to the ballencer with two screws then you turn the center screw in until the ballancer pops off ..
take the motor off the backside of the calliper and turn the screw in with a allen wrench then push the piston in
how do i fine the oil filler in a 2009 corolla and get a tool to take it off
What size is the tool to take the brakes off of a 99 kia sephia
you need to take out the screw on the arm rest, then take the screw out of the door handle, then slide off the platic piece that is around it. then the fun part the window crank... you have to pull on it because it is just a couve that is on it and when it pops off there is a nex screw and unscrew that. then u can go buy the right tool to take the panel off or you can shove in between to door panle and the door and get your fingers in there and just pull.... it is just christmass trees that are holding the door panel... hopes this helps.
Take off the caliper. Then the saddle. There will a screw holding the rotor on you will have to take that out. The best way to take it out is to buy a impact driver. But if you dont have one then just get the right screw driver and hit it with a hammer this will cause the screw to loosen.
Yes, it comes with an easy to use screw off back.
Take a screw that will fit tight in the hole in bottom screw it in tight and pull out the plug with a long screwdriver remove the screw
ok, take the screw in the door handle off, then whit a flat head take the red ligth at the bottom off, theres a screw in there take it off, then just pull the panel off, now do your thing and change the speakers