0
Most typical are spun rod bearings and scored bearing surfaces, increasing to knocking due to loose bearing, then piston rod breaking and cracking the block.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What is a low mu surface?
This is a low coefficient of friction like driving on ice with a car versus driving on dry asphalt.
Why is your car dying in the middle of you driving?
it might be because your car battery is low or dead
What can happen if you keep driving if car has a oil leak?
If it is leaky fast enough the oil can start a fire, also if it runs too low on oil it can cause severe mechanical damage.
Your car lost power while driving and now will not start?
my car has no power when driving. plus its hard to start. after i ran it low on fuel
When driving through fog what lights should be on in the car?
low lights
What does it mean when driving up a hill and the acceleration is low?
the car is weak
When driving in fog it is best to drive with?
When driving in fog it is best to drive with low your light on low beam. This will ensure that you get clear vision. You can use fog lights if you have them on your car and do not speed.
What does driving at low speed20mphin second gear for 10 - 15 minutes do to your car?
Not a lot.
What kind of damage is caused by switching into 4 low while driving?
Depending on speed. If not going to fast nothing then.
What is the typical rate a day for a budget car rental?
The typical rate a day for a budget rental car is $58, when the car is rented for one day only. If you rent the car for a whole week, the typical rate a day is as low as $12 per day. This shows that it is more economical to rent for more thsn just one day.
No heat in car when at stop light but fine when driving?
Check your coolant level it is probably low.
Car was low on gas after driving 200 miles straight put gas in car and car would not start up what could cause this?
dead battery
