0
What is uniformity of heating in the case of reheating furnace?
Wiki User
∙ 13y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why are the radiators warm but water is cold in a central heating system?
Central heating systems usually heat on a different system from the hot water heater, unless the main heater is a combination furnace/hot water heater. If this is the case, it could be because the outflow of hot water is greater than the ability of the furnace to heat the water.
How do you plumb a water line to a coal furnace to preheat the water prior to going into a electric hot water heater?
Is the furnace a hydroponic system? If it is you only need to get a heat exchanger (As you don't want the water to your heater flowing through the furnace) and plumb it as another zone in your house. If not you need to find a device for heating water that fits your furnace. and plumb the heat exchanger to that. I believe an heat exchanger is required by code in either case.
Is it possible to buy insurance on your furnace in case it needs to be replaced?
Yes you can
Closed container where ore is heated to extract metal?
Depending on the scale, it could be a crucible, a furnace or (only in the case of iron) a blast furnace.
Gas furnace lights but fan will not come on?
This can be caused by a couple of different reasons: 1. You could have a bad blower motor in which case the fan control will kick the burners out when it reaches the high limit which is a safety. 2. You could have a faulty fan control. In either case you should have a heating professional check the system out.
How is lead metal and zinc metal separated in a furnace?
A good method of separation in this case is distillation.
Expansion joints are used in bridges in order to prevent the bridge from?
Buckling; shriveling, bending, or curling from heating or pressure. (heating, in this case)
What is the code regulation for the conduit that the electrical wire goes through when going to the switch on a furnace?
The furnace control switch can be located on the outside of the furnace room. This is in case of an emergency with the furnace, no one has to enter the furnace room to isolate the furnace from its power supply. Code rule from the CEC (Canadian Electrical Code) 26-806 - 6 - The disconnecting means shall be permitted to be a branch circuit breaker at the distribution panel board, provided that the panel board is located between the furnace and the point of entry to the area where the furnace is located. 7 - Where a separate switch is required, due to the unsuitable location of the branch circuit breaker, it shall (a) not be located on the furnace in a location that can be reached only by passing close to the furnace; and (b) be marked to indicate the equipment it controls.
Can you plug your natural gas furnace into a 120 volt receptacle?
The furnace can be but it is not a good idea. Safety code requires a disconnect switch outside the area where the furnace is situated. This switch is used for an emergency shut down in case something electrically goes wrong with the furnace. In modern homes these furnaces are wired to a dedicated 120 volt circuit from the distribution panel. From the panel, the circuit is routed to the safety switch. From the safety switch, the circuit then continues to the furnace load.
How do you reset therapetic heating pad when it says F2?
The way to reset a therapeutic heating pad when it says F2 is to unplug the heating pad. It the error code F2 is still showing, you will need to call the company or return the heating pad in case of malfunction.
What kind of insurance should plumbing and heating companies have when they work on your house?
Heating and plumbing cpmpanies have contractors insurance. This protects both you and them in case something goes wrong.
Which gas is most important in the heating of your atmosphere?
The most important gas in this case is carbon dioxide.
