0
Transistors can be used to build amplifiers, oscillators, modulators, demodulators, switches, logic gates, etc. They replaced vacuum tubes and use much less power and don't have hot filaments that burn out giving them much longer life and higher reliability. They can be built microscopically on integrated circuit chips permitting circuits with billions of components to be built on an area less than one square centimeter.
What else can I help you with?
About A1015 pnp transistor?
how to use transistor a1015
Does CL100 transistor can be use at the place of SL100 transistor?
yes.
How do you use 'transistor' in a sentence?
I can give you several sentences.I bought a transistor radio.The transistor amplified the signal.We studied the transistor in science class.
What is the equivalent component to use in place sl100 transistor?
What is the equivalent component to use in place sl100 transistor? ...
How do you use the Transistor output terminals of an electronic counter in a Electrical control circuit?
They use transistor as the purpose to transfer the voltage
How do you use the word transistor in a sentence?
by adjective in the sentence
What is the typical use of a transistor in an analog circuit?
amplification
Why transistor burns?
If inceres the base voltage of transistor them it may be burn . The base volt may be 0.8v to 1.8 If it use as a amplifier
Is transistor a rectifier?
there are two diodes there but to use them as rectifiers never
What is direct couple transistor logic?
Direct coupled transistor logic is a type of transistor that is more economical to use then integrated circuits. These transistors can be found in many types of wires such as the ones that control cable internet.
Why NPN transistor are preffered?
You need a positive input to operate the transistor and since most circuits are negatively grounded when the transistor is not in use it has a negative input current thus using less power most of the time.
What is an unbiased transistor?
An unbiased transistor is one being used with no bias voltage to offset its operating point. If the input signal is very small it still can operate as an amplifier but the output will be non-linear. One use for an unbiased transistor is when the transistor is used as a switch, turning it on or off.
