Probably have a bad master cyclinder.
Usually means they probably didn't bleed the brakes or did not top off the brake fluid
Because something is wrong, take to a brake rather than risk your ( and OUR ) life.
Something is wrong with the Antilock Brake System . It could be a fuse , a sensor , or some other problem . As long as the BRAKE light in your dash is not on , you still have " normal " brakes
You either got the wrong master cylinder or you haven't actually bled all the air out of the system.
You did something wrong. -Go back over all steps carefully (preferably with manual) and see where you went wrong.
check fluid level
Something is wrong with the Antilock Brake System . It could be a fuse , a sensor , or some other problem . As long as the red " BRAKE " light in your dash is not lit up you still have " normal " brakes
LOW BRAKE FLUID!!! (very dangerous!) Fill reservoir, bleed the brakes, fill again to the correct level. After a few times braking, check fluid level. if fluid is lost, check brakes for leaks and have it fixed asap!!
Check your brakes to see if they are worn.
Something is wrong with the Anti-lock Brake System , it could be a fuse , a sensor , or some other problem . As long as the red BRAKE light is not on in your gauge cluster you still have " normal " brakes
There is something wrong with your Anti-lock Brake System , it could be a fuse , a sensor , or some other problem . As long as the BRAKE light is not on in your gauge cluster you still have " normal " brakes
The brake pads may not be adjusted properly. The wrong brake pads will also cause the brakes to drag. The brake pads may be too thick.