answersLogoWhite

0


Best Answer

It means that in your Grand AM SE 3.3 your emergency brake is broken.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is wrong when a 1992 Grand AM SE 3.3 has no reverse and seems like you have the emergencery brake on but all other forward gears work?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

A right rear tire goes in reverse but not forward?

Something is wrong in the brake.


What could cause a rear wheel to lock up in forward but not reverse?

The emergency brake cable is probably seized and the emergency brake is not releasing.


How come your emergency brake in your 1996 Jeep Grand Cherokee will hold in reverse but not forward after you just replaced the rear brake shoes?

If you did not have drums re-surfaced linings may have to be burnished (wear in) for a few hundred miles prior to obtaining full braking effect


How do i replace the rear brakes on a 1998 Pontiac grand am?

You will need to remove the tire and wheel from your 1998 Pontiac Grand Am. Remove the brake assembly spring from the brake pads. The brake pads will come off. Reverse the process to install the new brake pads.


How to install brakes for a 2002 Pontiac Grand Prix?

Remove the tire and wheel from your 2002 Pontiac Grand Prix. Remove the spring from the brake shoe. Remove the brake shoes. Reverse the process to install the new brakes.


When a car is moving in reverse backing from a driveway the driver applies the brake in what direction is the car's acceleration?

The car's acceleration is in forward direction.


How does reverse work on a waverunner?

The reverse on a waverunner works very similarly to the reverse on a jet plane. A mechanism called a "reverse gate" drops down over the jet on the back of the Waverunner. The reverse gate changes the direction of the thrust so that it goes forward instead of backward. With the thrust going forward, the Waverunner goes backward for the same reason it goes forward with the thurst going backward. Note that switching into reverse at speed or using the reverse at high speed or using the reverse as a brake can rip the pump out of the back of the Waverunner. The reverse is only intended for low-speed maneuvering.


What would cause my 2002 Impala to squeal whether brakes are or are not engaged while going straight in reverse but not while turning in reverse or in forward gears?

Inspect your brake pads. I would suspect they are worn out.


Why does the brakes on a 2002 Chevy Malibu's brakes lock up when put into reverse after being parked Going forward usually releases them?

back brake springs weak or broken! or a brake part is broken.


How do you replace the brake line on a grand am?

How do i replace brake lines on a 2000 grand am


What causes a jeep wrangler to go forward but locks the front tires in reverse?

One possibility is a brake caliper that has a broken or missing bolt. Or something has broken inside the front axle.


How do you put a Yamaha 250 in reverse?

If it is a Yamaha Bruin 250, 1. Stop the bike. 2. Keep the FOOT Brake and the RIGHT Hand Brake compressed. 3. Shift the bike into 1st (FIRST) gear. 4. Grasp the Forward/Reverse lever on the upper left side of the bike and move it left then down (towards the rear of the bike) and then move it right into Reverse. The red light (R)between the handle bars should come on. 5. LOOK BEHIND you before depressing the throttle slowly to back up. Reverse step 4 to put the bike back in Forward gear.