0
What is wrong with a 1991 Chevy Cavalier Z24 when it wont idle?
Wiki User
∙ 14y ago
possibly a vacuum leak, low fuel pressure, or the idle air control has failed,
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why might a 1991 Chevy Cavalier 4 cylinder idle too high?
Check for vacuum leak or faulty EGR valve.
What is the idle RPM for a 95 Chevy cavalier 22 liter with automatic transmission?
The idle on my 1995 Chevy Cavalier stays at 600rpm's when i check it with the scanner. Hope this helps BE SAFE dirt420ba
How do you adjust the idle on a 1991 Chevy Corvette?
== ==
Where is the idle air control valve in a 2004 Chevy cavalier?
The 2004 Chevrolet Cavalier idle air control valve can be found on the firewall in the engine compartment. The valve will be on the passenger side of the firewall.
How do you set idle speed for a 1991 Chevy beretta?
The idle speed is set at the factory and is NOT adjustable.
Wagon Chevy cavalier does not idle correctly when you come to stop you have to put it in neutral to keep an idle and even at that sometimes it turns off you recently changed the oxygen and idle?
spark plugs
Idle speed adjustment for a 1991 Chevy cheyene pickup?
replace the ecm
91 Chevy cavalier stars and when you idle it shots down?
fuel pressure reg throttle position or ASD relay
How do you adjust the idle on a 1988 Chevy Cavalier 2.0 four cylinder?
You can not adjust the idle screw, it is sealed off at the factory. If you are having a high idle problem check for a vacuum leak or a bad idle air control valve. These will commonly cause a high idle.
What is the idle RPM for a 95 Chevy cavalier 22 liter automatic transmission?
Listed under the hood on a placard and in the owner's manual.
What is the idle speed for a Chevy Cavalier?
82 to 94 as per a haynes manual, auto trans: 700 rpm and manual:750 rpms.
Removal of water pump pulley 1994 Chevy cavalier 2.2?
I have a knocking noise near the water pump pully or idler arm pully on my 94 chevy cavalier 2.2 motor when its at idle, if i give it more gas the noise will go away do you know what this could be? i took off the tension idle pully and checked the bearing and it was fine.
