bad switch or bad blower motor. i would go with the switch first as it is easier to access and cheaper. u can hotwire it and see if u can get the lower speeds. then go junkyard and get new switch
Blower motor relay is also somthing that will cause what you describe. Get a new one. You get junk from a junk yard.
The Blower Motor Resistor Pack is defective. Replace it. It is located on the passenger side by the blower motor. Very easy fix, 1 clip and 2 screws. Check RockAuto.com AIRTEX Part # 3A1287 for price and a great picture so you know what you are looking for. I just replace one today. It took about 10 minutes. I have seen the same problem on a number of vehicles.
How do you change brake pads for a 2000 Nissan Quest?
I AM GETTING A OBD CODE ERROR FOR MY 2000 NISSAN QUEST , PO141 AND PO325 ??? HOW DO I FIX IT..
how can i fix this problem, i have code 1320 in my 2000 Nissan quest,also this morning i could not start my car
inside the distributor
it has a timing belt
The 2000 Nissan Quest windshield wiper relay switch can be found on the firewall in the engine compartment. The windshield wiper relay switch will be on the passenger side of the firewall.
How does one reset service engine light on 2000 Nissan Quest Thanks Bill
Under the dashboard in the passenger side
According to the Gates website , the 3.3 liter V6 engine in a 2000 Nissan Quest has a timing BELT that is changed at 105,000 miles ( it is also an interference engine )
every 105000 miles
Does it turn over? Is it getting fuel? Is it getting spark?
Probably under vehicle-follow fuel line from tank
OEM says: P215/65R16 96S
1999-2002 Villager or Nissan Quest.
"http://wiki.answers.com/Q/Where_is_the_speed_sensor_on_a_2000_nissan_quest" and what is the sprk plug gap in inches
4 qt w/oil filter change.
You do not because there is a check valve in the filler to prevent gas spillage in case of a rollover.
Call your Nissan Dealer, they should be able to order that for you. I have a 1997 Nissan Quest, and I ripped the side-door handle off in an accident, I went to the dealer and they ordered it for me. However, it took over 3 months for me to get the part, because it has to be a special order with Nissan in Japan.
I have a 2000 quest, and the jack is under the 3rd row seat in a pouch anging, don't know if is the same in a 2006. Hope this helps.
Same line the dip stick goes in. Use a funnel and be careful with this.
Yes , it is an interference engine ( according to the Gates website , they make timing belts etcetera )
AnswerReplace the blower resistor.
A 2002 Nissan Frontier bed will not fit a 2000 Nissan frontier.