answersLogoWhite

0


Best Answer

Could be a number of things. Ignotion Coil bad,ignition switch bad?

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is wrong you changed the distrubutor and plug wires and there is no fire on your 92 Isuzu amigo 2.6?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you tell if a 1999 Isuzu amigo is a 4 or 6 cylinder?

Count the sparkplug wires.


1991 Toyota Camry changed alternator battery starter still wont start?

Check spark plug wires, and voltage on the distrubutor.


What does the O2 light stand for in an Isuzu Amigo?

The O2 light means the oxyogen sensor is needing to be replaced. It should be some where in the exhaust system.Answerit is located on the exhaust manifold with wires to a plug coming from it


How do you change spark plug and wires in 1998 Isuzu Hombre?

change plug wires on 1998 isuzu hombre 2.2


What is a distrubutor cap?

A Distributor cap is the device that the spark plug wires are connected to. It distributes spark from the ignition coil through the wires to each spark plug.


Changed the distrubutor plugs wires and still no fire to the plugs What is wrong with your 1997 sebring?

computer memory may be blank. if you unhooked your battery or it went dead for any period of time you may need to get your computer memory re flashed. cost is about 75 bucks at the dealer.


Where is the camshaft position sensor on a 1998 Isuzu amigo?

YOu need to remove the belt off the front of the engine, it is under the plastic cover in the top. It has three wires plugged into it. On mine one was black and blue, one was blue, and one was green. I found one at a wrecking yard.


What would cause F250 has miss no power when you push gas 1992 5.8?

proly needs a tune up most likely plugs wires distrubutor cap and rotor button


Where is the knock sensor in a Isuzu I290?

The knock sesor is located, on your Isuzu 1290, at the front of the engine. The sensor screws into the engine. Wires connect the sensor to the senor light.


How can the clutch switch be bypassed on a 1986 Isuzu pickup?

This is a safety issue but if you do it just connect the wires together.


Where is the o2 sensor on a 1995 Isuzu Rodeo?

its on the end of the wires just above the air filter housing unit


1988 V-6 Dodge Dakota how do the spark plug wires go on the distrubutor cap and where is 1 suppose to be?

you can check your local library for the chilton's manuel and xerox a copy and it will tell you word for word what you're looking for