The purge valve solenoid on your 2001 Chevy Cavalier is located on the side of the engine. It is mounted on the block right below the intake manifold and can be distinguished because of the bracket attached to it.
It is mounted above the valve body on a dodge 42re trans.
Yes, the Diamante has an EGR solenoid. On any Mitsubishi, if the car has an egr valve, it has a solenoid to operate the valve. Just follow the vacuum line from the valve and it will go to the solenoid. There may be another one way valve between the valve and the solenoid, though. The solenoid is electronic.
The vent valve is mounted underneath the vehicle in around the center point right next to the vapor canister (enclosed in metal box) mounted on same bracket that holds the canister.
The vent valve is mounted on a bracket near the fuel tank. Disconnect the electrical connector. Remove the hose from the vent valve. release the retainers and remove the vent valve from the bracket. It is under the truck.
The solenoid are on the valve body inside the transmission.The solenoid are on the valve body inside the transmission.
The EVAP vent valve/control solenoid is mounted on a bracket by the fuel tank. The EAVP purge valve/control solenoid is mounted on the front top of the intake manifold. Just behind the area where the throttle housing bolts to the front of the intake. It has an electric wires connected to it.
the DIN valve has a threaded opening
The vent valve is mounted on a bracket near the fuel tank. Disconnect the electrical connector. Remove the hose from the vent valve then release the retainers and remove the vent valve from the bracket. Installation is the reverse of removal.
A direct acting solenoid valve is one in which the action of the solenoid alone switches the valve gate. Most solenoid valves are "piloted", which means that a relatively small solenoid valve is used to allow pressurized air to actuate the valve gate mechanism. Because the solenoid does all of the work in a direct acting valve, the solenoid must therefore be larger than that of a piloted valve in order to generate the switching force. Piloted solenoid valves have the advantage of being more compact and consuming less current than a direct acting solenoid valve. Direct acting solenoid valves are useful when switching low pressure fluids.
The yoke's(!) on a motorcycle is the two plates of wich the front-telescopes, as well as the steering-axle, gets through. The handlebar are traditionally mounted on the upper yoke!
where is the purge solenoid valve on my camry 2001 6cyl