jacking oil is not required when stopping the steam turbine
The jacking point was the oil pan?
If you carry a gun you can stop car jacking.
You could if you have a short drain pan and very long arms.
under front exhaust manifold . change by jacking up car .make sure you use jack stand
A jacking oil pump also called a lift pump is commonly used on rotor shafts of steam driven Turbine Generators prior to startup or after shutdown to provide even cooling of the shaft and eliminate rotor distortion caused by sags due to weight and bows due to uneven cooling. The jacking oil pump uses high pressure oil supplied at the bearing journals to initiate an oil film and lift the shaft off its bearings. The rotor can then be put on a turning gear and rotated slowly to create even cooling and or roll out any distortions caused by the weight of the shaft while at rest. It also helps to maintain the oil film between shaft and the bearing till the rotor speed is adequate enough to maintain the film thickness and protects the shaft & bearing.
Under the jacking points but please refer to your owners manual First
Ball jacker is jacking of the balls and cock jacker is jacking of the cock and or balls and when you mix the two together it is a cock tittie jackin ball sucker please. that is what ball and cock jacking is :)
They are the places you would use when jacking up the vehicle for service, repair, or changing a wheel.
I-Jacking
swagger jacking
I-Jacking