if your Honda has a v-tech the igniton control should be on the left side of the engine and if it don't then look on the far right of the engine and it should be where the spark pulgs are.
You have the 1.6L(97.0cu.in.) I-4 SOHC SMPI 16 valve engine. You do not have the VTEC engine.
It will bolt right into the engine bay without a problem.
My Honda civic 2002 shakes fora few seconds as I turn the engine off.It happened right after replacing the engine mount on the driver's side.
They are right there on the top of the engine.
It is important to use the right type of engine oil in a car to help it run well. The 2006 Honda Civic uses 5w-30 engine oil.
From left to right on top of the engine, it goes 4 3 2 1, also make sure they are tight ater installing them!
The first thing to do if one cylinder is not firing on a 1989 Honda Civic SI, is to disconnect the battery. Then remove the spark plug wire and the spark plug. Check to see that there is no oil on the plug and it has the right gap measurement. Then replace the spark plug and wire and try the engine again. If it is still misfiring, change the spark plug. If that does not fix the problem, have a compression check done for that cylinder.
The oil sending unit on a 96 Honda Civic is right above the oil filter. The oil filter is on the back side of the engine.
its in behind the glove box to the right theres a button
There is a sensor right where the upper radiator hose goes into the engine.
The thermostat on a1998 Honda Civic is found on the right side of the engine. It is located in the thermostat housing which can be found by following the lower radiator hose.
The tension belt for a 1991 Honda Civic and located on the driver side of the engine. The pulley is right above the compressor.
A Honda Civic is a type of car that can be found used. If looking for a truck, this is not the vehicle for you. If looking for a car, then a Honda Civic is a step in the right direction.
needs an alignment...
No, it is illegal to remove a converter and besides the engine will not run right with the converter removed.
right at the end of the top radiator hose near the engine
That engine would fit any Honda civic 88-00 with the right motor mounts, and will fit right in into any other Acura integra
Whichever side you like. The car doesn't care.
On right-hand-drive models the engine E.C.U. is located behind the glovebox on the passenger side(Left).
Yes it has been done. You need the right engine mount, wiring, fabrication, ect.
The 2001 Honda Civic OBD 2 port is on lower right edge of dash; behind console trim
They are right in the front when you open your hood. Four wires go to the manifold, they are in there. Think it's a 13mm spark plug socket and an extension will be needed. It's easy as pie.
The 2001 Honda Civic OBD 2 port is on lower right edge of dash; behind console trim
Spark Plug Wires for my Honda Accord are as follows: 2 4 1 = 4 - 3 - 2 - 1 3 1 is the chamber to the far right. the diamond diagram represents the distributor cap if you were looking in from the left side of the car.