Want this question answered?
They (2ea.)are in the intake. The intake manifold will need to be removed to get to them. The wire harness and intake manifold gasket should both be replaced when reassembling.
"Quince" in Spanish translates to "fifteen" in English.
R134a
The egr valve on the 2002 explorer is on the right rear corner of the intake. The throttle body will need to be removed to access it.
Underneath the intake manifold, there is a front and rear, under a rubber seal with a wire leading to the sensor. You will need to remove wiring and lines above intake, and disconnect fuel line to rails before removing intake. You do not need to remove injectors.
what is the torque specs to a 2002 Chevrolet Malibu 3.1 liter motor. Need head and intake torque specs. and sequence.
Remove the pastic dome light cover and there are some small screws that need to be removed and the whole unit will be in you hand.
ON 2002 it is on the top right side of the engine between the intake manifold and timing belt housing, will need to remove the intake manifold and radiator to replace. 4 hrs work
FEL-PRO GASKETS,you will need port size,or go to SummitRacing.com
there is no MAF on the 2002 you have an MAP goes from the throttle body to the engine. sooo for a short ram or cool air intake its no prob and no need to mess with any harness or wires
for a Chevy 350 enginge its 25 to 30 ft lbs. cast iron heads.
10w 40 semi synthetic is what you need