Want this question answered?
A boring machine is used to enlarge a hole that has already been made, such as a gun barrel or a cylinder in an engine. By boring you can achieve greater accuracy in the diameter of what ever hole you are attempting to enlarge. You use different types of machines to achieve your purpose. This is a manufacturing process.
As a general rule, a bolt should engage a distancegreater than or equal to its outer diameter. The number of threads engaged can then be calculated from the number of threads per inch on the bolt. So if you are using a 1/4-20 bolt, meaning it has 1/4" diameter and 20 threads per inch, you should engage the bolt 1/4" into the hole, or 5 threads. (20 threads/inch x 1/4 inches)Why: The shear stress on the threads will be equal to the tensile stress in the shank of the bolt. This means that once you thread the bolt in a distance greater than its diameter, the shank itself will fail before the threads shear off the bolt under tensile load.Sources: Design of Machinery class at Purdue University, page 10 of the following MIT article: http://web.mit.edu/2.75/resources/FUNdaMENTALs%20Book%20pdf/FUNdaMENTALs%20Topic%206.PDF
H6 tolerance for 95 mm hole is +0.022/0
Tolerances H7 23DIA for hile is +0.021/-0.000 ///MUKI
http://wiki.answers.com/Q/What_is_The_tolerance_for_a_08mm_H12_hole"
The bore is the inside of the barrel- that is, the hole that the bullet is fired through. The diameter of the bore is measuring how wide the bore is from one side to another.
PCD (Pitch Circle Diameter) is the diameter of a circle that goes through each of the bolt holes. You can find it by measuring distance from centre of one bolt hole to the centre of opposite end bolt hole...
00 Jeep Grand Cherokee, measurement of caliper from pin hole to pin hole.
4.24563 inches is the diameter of a golf hole.
4.25 inches is the current size of a golf hole
yes probably but i would seriously recommend just buying a new caliper
The "diameter" of a black hole is usually taken as the diameter of the event horizon.
There is no such hole.
The diameter is usually considered the diameter of the event horizon. The diameter of this event horizon is directly proportional to the black hole's mass. More information at http://en.wikipedia.org/wiki/Schwarzschild_radiusThe diameter is usually considered the diameter of the event horizon. The diameter of this event horizon is directly proportional to the black hole's mass. More information at http://en.wikipedia.org/wiki/Schwarzschild_radiusThe diameter is usually considered the diameter of the event horizon. The diameter of this event horizon is directly proportional to the black hole's mass. More information at http://en.wikipedia.org/wiki/Schwarzschild_radiusThe diameter is usually considered the diameter of the event horizon. The diameter of this event horizon is directly proportional to the black hole's mass. More information at http://en.wikipedia.org/wiki/Schwarzschild_radius
CD's have a diameter of 5.5 centimeters;)
You can develop a hole saw cutter for the purpose, with a pilot.
cut a ragged hole with scissors. then to smooth it out heat a measuring spoon in a stove fire. the spoon should be very HOT. put the spoon on the edge of the ragged hole, and the plastic on the sides should melt. smooth the hole out and presto!