H6 tolerance for 95 mm hole is +0.022/0
Tolerances H7 23DIA for hile is +0.021/-0.000 ///MUKI
http://wiki.answers.com/Q/What_is_The_tolerance_for_a_08mm_H12_hole"
UPPER TOLERANCE: 0.0MM LOWER TOLERANCE: -.062MM Source: Michelin Quality Requirements Manual 1993
unilateral tolerance is a process of giving tolerance in one direction only ex if 10 is the basic dimension then the unilateral tolerances for it an be -0.007 or -0.004 etc..... but should be inthe same direction
Mechanical tolerance is the permissible limits or limits of variation in physical dimension. This can also be defined as the limit between a bolt and a nut.
+19/-0 micrometres for H6 over 50mm up to 80mm dia
h stands for standard hole in tolerance
Tolerances H7 23DIA for hile is +0.021/-0.000 ///MUKI
10H7 (Hole!- negative cote) (biggest) is from +10,018 to +10,000 tolerance. 10h7 (shaft - positive cote) is from +10,000 to +9,982 tolerance.
3.74 inches
9.5mm = 0.95cm
+0.021 -0.00
95 mm = 0.095 m, so 95 mm squared = 0.009 sq m. Note, when you say 95mm squared I assume you mean a square of side 95mm, this area will be 9025 sq mm, not 95 sq mm.
The answer will depend on what 19b4 and h6 are.
95 millimeters is 9.5 centimeters.
your h6 has a timing chain
http://wiki.answers.com/Q/What_is_The_tolerance_for_a_08mm_H12_hole"