0
What else can I help you with?
Where is the low coolant sensor located on a 1996 Chevy Cavalier?
Should be at the lower section of the coolant recovery tank
Where is the low coolant sensor on a 1996 lumina car?
It should be located in the recovery tank.
How should I add coolant to a 1996 Mercury Villager?
Slowly to prevent an "air lock" through the top of radiator or through coolant recovery tank
Where is the obd plug on a 1996 montero?
It is under the dash on the driver side.
What type of antifreeze does a 1996 Pontiac sunfire use?
A 1996 Pontiac Sunfire uses Dexcool coolant. This should only be mixed with distilled water, never tap water. Replace the coolant every 2 years or as needed.
What color and type of engine coolant should be used in a 1996 Suburban?
General Motors changed to Dexcool Extended Life coolant in 1996. It is the orange colored coolant. Green coolant will not hurt the system, it must be replaced about 5 times as frequently though. Beware that once you use green coolant in your cooling system, it is very dificult to remove completely if you want to use the extended life coolant in the future.
How to remove a power steering belt on a 1996 montero?
Use a knife and cut it
Where is the radiator drain plug for a 1996 Mitsubishi Montero?
there should be a drain plug on all radiators on the bottom of radiator on either bottom corner or possibly in middle on bottom
Where is the water outlet housing on a 1996 Chevy cavalier?
Connected to the upper radiator hose. Coolant flows from the engine to the radiator to be cooled. The coolant temp. sensor should be screwed into it.
Where do you put coolant in 1996 Hyundai Sonata?
Coolant is added to a 1996 Hyundai Sonata by opening the coolant overflow tank and adding coolant until the full mark is reached. This allows the cooling system to pull in coolant as needed from the reserve tank.
How do you replace the water pump on a 1996 Mitsubishi Montero 3.0?
The replacing of the water pump assembly of this application is of skilled difficulty. The first steps are the removal of the drive belts. Once they are cleared the coolant hoses can be disconnected. Finally the water pump assembly bolts can be removed from the engine. The gasket material should be cleaned to ensure a correct seal. The new pump can be installed and the belts rerouted to original layout. The vehicle should be the purged and recharged with fresh coolant. Lastly, the engine and heater should be turned on to inspect for function and possible leaks.
Where is the Coolant Level Sensor on a 1996 Aurora?
Its located on the bottom of the coolant reservore.
