The replacing of the water pump assembly of this application is of skilled difficulty. The first steps are the removal of the drive belts. Once they are cleared the coolant hoses can be disconnected. Finally the water pump assembly bolts can be removed from the engine. The gasket material should be cleaned to ensure a correct seal. The new pump can be installed and the belts rerouted to original layout. The vehicle should be the purged and recharged with fresh coolant. Lastly, the engine and heater should be turned on to inspect for function and possible leaks.
no.
The filter is somewhere underneath the skid plate in the front of the car...
right front valve cover open the hood and on the drivers side valve cover in the front you will see it
there should be a drain plug on all radiators on the bottom of radiator on either bottom corner or possibly in middle on bottom
The 1992, 1993, 1994, 1995, 1996 & 1997 Mitsubishi Montero LS takes a 14" replacement rear wiper blade. Note however, when buying wipers be sure to always lookup your vehicle make, model and year in the application guide book at the store
drain the coolent remove timing belt.....loosen bolts....4g63, take off accessory belts and remove
If you go to autozone.com you can view repair guides online free.
How do you replace the water pump and where is it located on a 1996 Buick Skylark V6
where is the oxygem sensor on 1996 Mitsubishi mirage
go to autozone.com and go to vehicle repair guides
How can do I replace a water pump on a 96 camaro z28
does Mitsubishi mirage have a map sensor 1.5 1996