You will find either of following engines in 1991 Ford Bronco. These engines are (1) 300 cu.in strait -6 (2)302 cu in 302 V8 (3)351 cu in Windsor V8
No, the front end of 92 - 96 Broncos is completely different than 87 - 91 Broncos.
91 Ford bronco 5.0 you will find the PCV underneath the upper intake manifold toward the rear of the top of the valve cover. It will have a rubber vacuum line attached to it.
An AOD transmission can go into a 91 Bronco with a little fabrication.
5w3o
On the 91 5.8L, and Im sure the 93 is the same. Its located at the rear of the engine, on the passenger side. its a short small hose attached to the top of it and about a 3/8" hose on the bottom. This hose goes into the intake, behind the air intake housing, its kind of hard to get it back in, but you can do it
15x7, so 7 inches wide. i have a 91 with optional factory rims that are 15x10
probably not being that the engine in the escort was manufactured by ford and 2 liter in the probe was manufactured by Mazda
For a 1991 Ford Explorer , 4.0 litre V6 engine : ( 5W-30 ) * if you never drop below the freezing temperature then 10W-30 is fine
If the motor is a 5.8L Windsor the Coil is directly under the distributor cap in the front of the motor on the right hand side.
what is the engine size? That is missing information. Are you asking about the ignition system? If you are, I can give you the exact information from a the Haynes Ford Ranger & Bronco II 1983 thru 1992 2WD and 4WD models with a gasoline engine Repair Manual if you give me this tiny bit of information
oil capacity 91 ford 7.3 diesel
The 91-97 TC has a standard 4.6L engine.